HP Omi 10: remote agent operation opr-agt command - General

The opr-agt Command-Line Interface

You can use the opr-agt command-line interface (CLI) to manage and configure the HP Operations Agent on one or more monitored nodes:

• Get the current status of the agent processes.
• Start or restart the agent processes.
• Shut down (stop) the agent processes.
• Return the version number of the installed HP Operations Agent software.
• Return the setting of configuration variables.
• Set configuration variables to a specified value.
• Switch the primary manager.
• Deploy configuration.
• Sets the primary manager for event reception (primary event receiver)

This command equivalent to opcragt on the HP Operation Manager.

The opr-agt command-line interface first contacts the RTSM to retrieve a list of monitored nodes. It then contacts up to 50 nodes in parallel to perform the requested operation. When you run an operation on more than one monitored node, opr-agt displays the status immediately after a remote operation finishes for each node. 

You can run opr-agt on a gateway or a data processing server. On the server, the server processes must be running, and the ovcd and ovbbccb processes must be running on the monitored node.

Location

<OMi_HOME>/opr/bin/opr-agt 

Synopsis

opr-agt <BSM_CONNECTION> <operation> <targets> <authentication> <toolInfo> 

Please follow the below link to see more detail explanation for each option:

<BSM_CONNECTION>